Difference between revisions of "ICnova ADB4003"
Line 46: | Line 46: | ||
{{Modules|intro}} | {{Modules|intro}} | ||
{{Modules|header}} | {{Modules|header}} | ||
− | {{Modules| | + | {{Modules|sam5}} |
− | + | ||
{{Modules|footer}} | {{Modules|footer}} | ||
Revision as of 17:25, 30 September 2014
Contents |
Hardware
The ICnova ADB4003 is a ready to go touch display solution with 5inch display and ICnova SAMA5D36 SODIMM. Just connect to power and see the Linux booting up in display!
The ICnova ADB4003 is designed for:
- Smart Home Applications
- Data logger for Solar applications
- Industrial control devices
The ICnova ADB4003 has the following features:
- 2x 10/100 Base-T-Ethernet-Port
- 2x High-Speed-USB 2.0 Host ports
- 1x High-Speed-USB 2.0 Device Port
- 1x TFT-Touchscreen display connector
- 1x SD/MMC card holder with MMI interface
- 1x DBG UART
- 2x isolated RS485 interfaces
- 1x isolated RS422 interface
- 1x CAN interface
- 1x RS232 interface
- 1x I2C interface
- 1x Buzzer
- 1x Real-Time-Clock battery buffered
- 3x GPIO pinheader
- 1x JTAG-interface (compatible with JTAGICE-mkII)
- 1x SPI-interface (for flash programming)
- Dimensions: 200mm x 140mm
- Temperature range from -40°C to +85°C
- Input voltage: 24V DC
The ICnova ADB4003 and appropriate ICnova CPU-Modules can be ordered at our Shop
Suitable CPU Modules
Software
All Modules provided by In-Circuit usally have a Buildroot based system preinstalled, so they can be used out of the box.
Login as "root" for which no password is set.
If you are new to kernel building please refer to First Steps with Buildroot.
The Board support packages listed in table above contain all sources required to build the linux image for the different combinations with the ICnova ADB4003.
If an older version of the BSP is needed please look at our Downloads section.
Generally the bootloaders on our modules are configured to loook for a bootable linux image on the SD-Card and only boot from flash if none is found.