Difference between revisions of "radino UART-Bridge"
From InCircuit
| Line 3: | Line 3: | ||
[[File:radino UART top 640.jpg | x300px | top | link=http://shop.in-circuit.de/product_info.php?cPath=22_28&products_id=173]] | [[File:radino UART top 640.jpg | x300px | top | link=http://shop.in-circuit.de/product_info.php?cPath=22_28&products_id=173]] | ||
[[File:radino UART bot 640.jpg | x300px | top | link=http://shop.in-circuit.de/product_info.php?cPath=22_28&products_id=173]]<br/> | [[File:radino UART bot 640.jpg | x300px | top | link=http://shop.in-circuit.de/product_info.php?cPath=22_28&products_id=173]]<br/> | ||
| − | The In-Circuit radino UART-Bridge is a breakout board for | + | The In-Circuit radino UART-Bridge is a breakout board for radino modules. The serial communication pins (RX, TX, RST, HWB) are available on pin headers, so the radino UART-Bridge can be used as a serial UART to radio bridge. It converts a serial UART Signal into a radio signal.<br/> |
| − | Depending on the used radino module, different kinds of radio networks can be built up. | + | Depending on the used radino module, different kinds of radio networks can be built up.<br/> |
| − | The radino UART-Bridge is compatible to all radino modules. | + | The radino UART-Bridge is compatible to all radino modules.<br/> |
| − | The radino module can be programmed with the Arduino IDE via ISP connector at the bottom side. | + | The radino module can be programmed with the Arduino IDE via ISP connector at the bottom side.<br/> |
'''Features:''' | '''Features:''' | ||
| Line 18: | Line 18: | ||
==Downloads== | ==Downloads== | ||
[[Media:305000085A_radino_UART-Bridge.pdf | Datasheet {{PAGENAME}}]]<br/> | [[Media:305000085A_radino_UART-Bridge.pdf | Datasheet {{PAGENAME}}]]<br/> | ||
| − | |||
[[Media:610000306A01_Layoutschaltplan_radino_UART-Bridge.pdf | Schematics {{PAGENAME}}]]<br/> | [[Media:610000306A01_Layoutschaltplan_radino_UART-Bridge.pdf | Schematics {{PAGENAME}}]]<br/> | ||
Revision as of 13:30, 31 March 2015
Hardware
The In-Circuit radino UART-Bridge is a breakout board for radino modules. The serial communication pins (RX, TX, RST, HWB) are available on pin headers, so the radino UART-Bridge can be used as a serial UART to radio bridge. It converts a serial UART Signal into a radio signal.
Depending on the used radino module, different kinds of radio networks can be built up.
The radino UART-Bridge is compatible to all radino modules.
The radino module can be programmed with the Arduino IDE via ISP connector at the bottom side.
Features:
- Arduino-compatible (Arduino Micro / Leonardo)
- UART pins on pin headers in 2.54mm pitch
- RP-SMA socket for antenna connection
- Dimensions: 46.0x19.5mm
- ISP connector on bottom side to program the radino module
- Reset button on bottom side
