radino software

From InCircuit
Revision as of 10:45, 9 February 2017 by CGruenig (Talk | contribs)

Jump to: navigation, search
radino Library
radino radino32
radino32 software
radino software
radino common problems
radino WiFi software
First Steps | Howto | FAQ
IC ESP ESP8266EX HTTPD IC ESP8266EX interface

How to setup the Arduino IDE for use with the radino modules.

Contents

Arduino IDE



Arduino IDE


radino support files

Downloadpage for radino library

  • Unzip the downloaded file, after it you now have two folders (hardware and libraries) and a file (README.txt):


Arduino Files


  • Now copy both folders into your main Arduino-Sketch folder.
    This folder was specially defined during installation or has one of the following default paths (english and german):
My Documents\Arduino
C:\Documents and Settings\yourUserName\My Documents\Arduino
C:\Users\yourUserName\Documents\Arduino
Eigene Dateien\Arduino
C:\Dokumente und Einstellungen\ihrBenutzerName\Eigene Dateien\Arduino
C:\Benutzer\ihrBenutzerName\Eigene Dateien\Arduino

radino connection

  • The Figure shows minimal USB setup:


radino Wiring


driver and serial port

  • When first using radino, a driver installation is required.
    If asked for the driver, just point the driver installer tool to the radino driver folder:


radino Driver


  • Your computer now assigns a serial port.You can see a new com port in windows device manager:


radino Port


sketch upload

  • Open Arduino IDE and select one of the variuos available example sketches for radino:


Arduino IDE Example


  • Choose your corresponding radino to which you want to upload the sketch:


Arduino IDE Board


  • Select the corresponding serial port


Arduino IDE Port


  • upload your sketch


Arduino IDE Upload


  • open the serial monitor to communicate with radino


Arduino IDE Monitor


Troubleshooting

  • When experiencing problems while uploading, try one of the following methods to fix communication problems of the Arduino IDE.
  • 1. After clicking "Compile & Upload", double-press the reset button of your radino. This will force your radino to enter the bootloader.
  • 2. Disconnect your radino, close all Arduino IDE windows, reconnect your radino and then start the Arduino IDE again.
Personal tools