radino Modules
From InCircuit
The core of radino is an Arduino Micro, so the programming is as easy as programming an Arduino Micro.
Visit radino software for more information about the Arduino IDE.
We offer a continuously growing Arduino Lib with Drivers, Libs and Examples for our radino Modules:
http://www.ic42.de/BSP/radino/ICT_Boards.zip
All our radino modules fit in the radino Leonardo evaluation board.
It's a easy way to connect to radino modules.
Board | Pictures | Description | Notes |
---|---|---|---|
radino nRF8001 | Bluetooth v4.0 compliant, 15 GPIOS, I²C, SPI, UART, USB HID | ||
radino WiFi | 802.11 b/g/n, integrated TCP/IP protocol stack, 15 GPIOS, I²C, SPI, UART, USB HID | ||
radino CC1101 | integrated CC1101 HF frontend for 433/868/915MHz, 15 GPIOS, I²C, SPI, UART, USB HID | ||
radino RF69 | integrated RF69 HF frontend for 433/868MHz, 15 GPIOS, I²C, SPI, UART, USB HID | ||
radino Leonardo | Carrier board suitable for all radino Modules | ||
radino DinRail Adapter | DinRail Adapter to connect any radino Modules | ||
radino Spider 2.4G | Breadboard Adapter for radino WiFi and Bluetooth Modules | ||
radino Watch | Battery powered wearable smart device |
Common problems and solutions
Uploading a sketch through the arduino IDE fails
Enable verbose output via "File->Preferences" select checkboxes "compilation" and "upload" near "Show verbose output during:"
Check verbose error messages during compilation and upload
- arduino IDE successfully finds the COM port but avrdude stops after an output like
Connecting to programmer: .avrdude: Send: . [1b] avrdude: Send: S [53] avrdude: Recv:
- -> Force the arduino into bootloader by pressing reset button twice when the arduino IDE starts scanning the COM ports
- arduino IDE successfully finds the COM port but avrdude stops after an output like
avrdude: ser_send(): write error: sorry no info avail
- -> Force the arduino into bootloader by pressing reset button twice when the arduino IDE starts scanning the COM ports
- arduino IDE fails after scanning the COM ports with an message like
processing.app.debug.RunnerException: Couldn’t find a Leonardo on the selected port. Check that you have the correct port selected
- -> Force the arduino into bootloader by pressing reset button twice when avrdude starts scanning the COM ports
- -> Disconnect the arduino from USB and reconnect after some seconds
- -> Maybe a restart of the arduino IDE is necessary.