DIN Rail Relais 6I6S

From InCircuit
Revision as of 14:12, 9 October 2013 by Benjamin (Talk | contribs)

Jump to: navigation, search

Template:Under construction

Hardware

DIN Rail Relais 6I6S - 6 Chanel Relais Module

DIN Rail Relais 6I6S


The device DIN Rail Relais 6I6S is equipped with an ATXMEGA 128µC.


Features:

  • ATXMEGA 128µC
  • 6x Binary input (24 - 230V AC/DC)
  • 6x Relais output (COM, NO, NC), switching power: 230V/5A
  • Each 1x UART for uplink and downlink
  • 1x RS485 via BUS connector
  • Arbitrary number of modules mountable side by side
  • Easy connection of all modules with BUS connector
  • All modules can communicate via UART and RS485
  • DIN-Rail enclosure: 6 pitch units (div)
  • Other DIN-Rail modules available
  • Input voltage: 24V DC
  • Tempearture range from -10°C to +70°C


Railbus Registers / Sub addresses

Communicating via the DIN Rail BUS Protocol, the DIN Rail Relais 6I6S implements two registers. Both registers have the same layout:


SADR 31 - 22 21 - 16 15 - 6 5 - 0
0 0 DIGIN 0 RELAIS R
0 0 0 0 RELAIS W
1 0 DIGIN 0 RELAIS R
1 0 0 0 RELAIS W

On reading, the current status of all Pins is transmitted. If the first relais is on, bit 0 is set. If the second relais is on, bit 1 is set, and so on.

On writing only the 6 lowest bits are interpreted, and the relais set accordingly.

Writing to SADR 0 sets the relais only temporary. After a power-cycle all relais will be set to their initial state. This can be set by writing to SADR 1. In this case the state is set and stored in EEProm.

Downloads

Datasheet DIN Rail Relais 6I6S

Personal tools