Difference between revisions of "NAND-Connection ICnova SAM9G45"
From InCircuit
(Created page with 'The NAND-Flash used on ICnova SAM9G45 OEM and ICnova SAM9G45 SO-DIMM is the same and connected equally. The following parameters are met for this device: {| class="wikitable" |-…') |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | The NAND-Flash used on ICnova SAM9G45 OEM and ICnova SAM9G45 | + | The NAND-Flash used on [[ICnova SAM9G45 OEM]] and [[ICnova SAM9G45 SODIMM]] is the same and connected nearly equally. The following parameters are met for this device: |
{| class="wikitable" | {| class="wikitable" | ||
| Line 15: | Line 15: | ||
| '''CLE-AddressBit''' || 22 (0x40400000) | | '''CLE-AddressBit''' || 22 (0x40400000) | ||
|- | |- | ||
| − | | '''CE on GPIO''' || PortC | + | | '''CE on GPIO''' || PortC Pin8 on OEM, Pin 14 on SO-DIMM |
|- | |- | ||
| − | | '''RnB on GPIO''' || PortC | + | | '''RnB on GPIO''' || PortC Pin11 on OEM, Pin 8 on SO-DIMM |
|} | |} | ||
To acccess the NAND-Device using a custom bootloader, the AT91SAM9G45 EBI Interface must be configured accordingly and the EBI_CS3A Bit in the EBICSA Register must be set to activate NAND-Logic. | To acccess the NAND-Device using a custom bootloader, the AT91SAM9G45 EBI Interface must be configured accordingly and the EBI_CS3A Bit in the EBICSA Register must be set to activate NAND-Logic. | ||
| − | [[Category:ICnova_SAM9G45]] | + | [[Category:ICnova_SAM9G45]] [[Category:HowTo]] |
Latest revision as of 15:16, 19 December 2013
The NAND-Flash used on ICnova SAM9G45 OEM and ICnova SAM9G45 SODIMM is the same and connected nearly equally. The following parameters are met for this device:
| Typ | NAND02GW3B2 |
| VCC | 3.3V |
| Buswidth | 8bit |
| Startaddress | 0x40000000 |
| ALE-AddressBit | 21 (0x40200000) |
| CLE-AddressBit | 22 (0x40400000) |
| CE on GPIO | PortC Pin8 on OEM, Pin 14 on SO-DIMM |
| RnB on GPIO | PortC Pin11 on OEM, Pin 8 on SO-DIMM |
To acccess the NAND-Device using a custom bootloader, the AT91SAM9G45 EBI Interface must be configured accordingly and the EBI_CS3A Bit in the EBICSA Register must be set to activate NAND-Logic.
