Programmer

ICprog OpenOCD

USB-A UART Bridge CP2104

The USB-UART-Bridge connects UART components with an USB-Host. The Bridge generates a 3.45V Voltage from USB. This can be used to supply the microcontroller over a jumper (maximum 100mA@3.45V).

Features:

• Baud rate: 300Bit/sec up to 2MBit/sec
• GPIOs 0-3 are set to push/pull at delivery state! (so LEDs, TxEN and GPIO are working)
• Voltage-regulator: up to 100mA@3.45V
• LEDs: Power, RX and TX
• IO: RX ( to connect with RX on the µC),TX (to connect with TX on the µC), GND, VCC
• Size: (LxWxH)(mm): 52.0 x 17.0 x 5.2

Downloads:

• Driver: CP201x Driver
  
• Datasheet: Datasheet USB-A UART Bridge CP2104
  
• Schematic: Schematic USB-A UART Bridge CP2104
  
  

The USB-A UART Bridge CP2104 can be ordered at our Shop