Programmer
From InCircuit
ICprog OpenOCD
The USB-UART-Bridge connects UART components with an USB-Host. The Bridge generates a 3.45V Voltage from USB. This can be used to supply the microcontroller over a jumper (maximum 100mA@3.45V).
Features:
- Baud rate: 300Bit/sec up to 2MBit/sec
- GPIOs 0-3 are set to push/pull at delivery state! (so LEDs, TxEN and GPIO are working)
- Voltage-regulator: up to 100mA@3.45V
- LEDs: Power, RX and TX
- IO: RX ( to connect with RX on the µC),TX (to connect with TX on the µC), GND, VCC
- Size: (LxWxH)(mm): 52.0 x 17.0 x 5.2
Downloads:
- Driver: CP201x Driver
- Datasheet: Datasheet USB-A UART Bridge CP2104
- Schematic: Schematic USB-A UART Bridge CP2104
The USB-A UART Bridge CP2104 can be ordered at our Shop
ICprog-AVR2.0 / KANDA
Wiggler