radino UART-Bridge
From InCircuit
Hardware
The In-Circuit radino UART-Bridge is a breakout board for radino modules. The serial communication pins (RX, TX, RST, HWB) are available on pin headers, so the radino UART-Bridge can be used as a serial UART to radio bridge. It converts a serial UART Signal into a radio signal.
Depending on the used radino module, different kinds of radio networks can be built up.
The radino UART-Bridge is compatible to all radino modules.
The radino module can be programmed with the Arduino IDE via ISP connector at the bottom side.
Features:
- Arduino-compatible (Arduino Micro / Leonardo)
- UART pins on pin headers in 2.54mm pitch
- RP-SMA socket for antenna connection
- Dimensions: 46.0x19.5mm
- ISP connector on bottom side to program the radino module
- Reset button on bottom side
