Difference between revisions of "radino software"

Revision as of 17:58, 19 March 2015 (view source) TBlocher (Talk | contribs) ← Older edit		Revision as of 10:22, 24 March 2015 (view source) EThomas (Talk | contribs) Newer edit →
Line 4:		Line 4:
	|-		|-
	|[[radino software]]		|[[radino software]]
−	'''How to setup the Arduino IDE.'''
	|colspan=3 | [[radino WiFi software]]		|colspan=3 | [[radino WiFi software]]
−	Overview about software running on Radion WiFi	+	[[radino WiFi software#First_Steps|First Steps]] | [[radino WiFi software#Howto|Howto]] | [[radino WiFi software#FAQ|FAQ]]
	|-		|-
	|		|
	|[[IC ESP]]		|[[IC ESP]]
−	library implementing the ESP8266EX Library
	|[[ESP8266EX HTTPD]]		|[[ESP8266EX HTTPD]]
−	how to write webpages
	|[[IC ESP8266EX interface]]		|[[IC ESP8266EX interface]]
−	In-Circuit ESP8266EX (lowlevel) interface
	|-		|-
	|}		|}
		+
		+	How to setup the Arduino IDE for use with the radino modules.
	== Arduino IDE ==		== Arduino IDE ==

---

Revision as of 10:22, 24 March 2015

	radino Library
radino software	radino WiFi software First Steps | Howto | FAQ
	IC ESP	ESP8266EX HTTPD	IC ESP8266EX interface

How to setup the Arduino IDE for use with the radino modules.

Contents 1 Arduino IDE 2 radino support files 3 radino connection 4 driver and serial port 5 sketch upload 6 Troubleshooting

Arduino IDE

• Visit http://www.arduino.cc/en/Main/Software and download the latest version of Arduino IDE
• Install Arduino IDE on your computer
• Now start Arduino IDE. If installed properly, a windows like this should open:

radino support files

• Visit http://www.in-circuit.de/ or http://www.radino.cc/ to download the latest In-Circuit Arduino SW Support Package or use the link below:

http://www.ic42.de/BSP/radino/ICT_Boards.zip

• Unzip the downloaded file, after it you now have two folders (hardware and libraries) and a file (README.txt):

• Now copy both folders into your main Arduino-Sketch folder.
  This folder was specially defined during installation or has one of the following default paths (english and german):

My Documents\Arduino
C:\Documents and Settings\yourUserName\My Documents\Arduino
C:\Users\yourUserName\Documents\Arduino

Eigene Dateien\Arduino
C:\Dokumente und Einstellungen\ihrBenutzerName\Eigene Dateien\Arduino
C:\Benutzer\ihrBenutzerName\Eigene Dateien\Arduino

radino connection

• The Figure shows minimal USB setup:

driver and serial port

• When first using radino, a driver installation is required.
  If asked for the driver, just point the driver installer tool to the radino driver folder:

• Your computer now assigns a serial port.You can see a new com port in windows device manager:

sketch upload

• Open Arduino IDE and select one of the variuos available example sketches for radino:

• Choose your corresponding radino to which you want to upload the sketch:

• Select the corresponding serial port

• upload your sketch

• open the serial monitor to communicate with radino

Troubleshooting

• When experiencing problems while uploading, try one of the following methods to fix communication problems of the Arduino IDE.
• 1. After clicking "Compile & Upload", double-press the reset button of your radino. This will force your radino to enter the bootloader.
• 2. Disconnect your radino, close all Arduino IDE windows, reconnect your radino and then start the Arduino IDE again.