Difference between revisions of "radino software"

Latest revision as of 10:40, 25 July 2017

How to setup the Arduino IDE for use with the radino modules.

[edit] Arduino IDE

• Attention: When using radino32-modules, please also refer to radino/radino32 software

• Visit http://www.arduino.cc/en/Main/Software and download the latest version of Arduino IDE (on radino32 use Arduino 1.6.0 / 1.6.1)
• Install Arduino IDE on your computer
• Now start Arduino IDE. If installed properly, a windows like this should open:

[edit] radino support files

• Visit http://www.in-circuit.de/ or http://www.radino.cc/ to download the latest In-Circuit Arduino SW Support Package or use the link below:
  • Downloadpage for radino library
• Unzip the downloaded file, after it you now have two folders (hardware and libraries) and a file (README.txt):

• Now copy both folders into your main Arduino-Sketch folder.
  This folder was specially defined during installation or has one of the following default paths (english and german):

My Documents\Arduino
C:\Documents and Settings\yourUserName\My Documents\Arduino
C:\Users\yourUserName\Documents\Arduino

Eigene Dateien\Arduino
C:\Dokumente und Einstellungen\ihrBenutzerName\Eigene Dateien\Arduino
C:\Benutzer\ihrBenutzerName\Eigene Dateien\Arduino

[edit] radino connection

• The Figure shows minimal USB setup:

[edit] driver and serial port

• When first using radino, a driver installation is required.
  If asked for the driver, just point the driver installer tool to the radino driver folder:

• Your computer now assigns a serial port.You can see a new com port in windows device manager:

[edit] sketch upload

• Open Arduino IDE and select one of the variuos available example sketches for radino:

• Choose your corresponding radino to which you want to upload the sketch:

• Select the corresponding serial port

• upload your sketch

• open the serial monitor to communicate with radino

[edit] Troubleshooting

• When experiencing problems while uploading, try one of the following methods to fix communication problems of the Arduino IDE.
• 1. After clicking "Compile & Upload", double-press the reset button of your radino. This will force your radino to enter the bootloader.
• 2. Disconnect your radino, close all Arduino IDE windows, reconnect your radino and then start the Arduino IDE again.