radino/radino32 software

new page under construction

This page discripes how to install the Arduino IDE, add our radino library and install an example on a radino and a radino32.

Install driver

on radino32

• After entering the Bootloader windows will detect the new device.
• Use the zadig driver installation tool under "%ARDUINO_APPDATA_FOLDER%/hardware/ICT_Boards/stm32l1/driver/win" to install drivers for the STM32 Bootloader.
• Make sure within the installation tool "libusbK (v3.0.7.0)" is selected.

• Windows 7 usually installs the wrong driver for radino32 automatically - this guide shows how to remove the wrong driver and install the right one.

Uninstall wrong driver

• Open the device manager
• Within section USB-Controller look for STM Device in DFU Mode
  • If you formerly used another device from ST and installed a driver package, the device STM32_BOOTLOADER within another section might be the one to look for.
• Right-click on that entry and choose Uninstall

• In the upcoming window check the box and click OK

• Now disconnect the radino32 from your PC (remove the USB connection)

Reconnect radino 32 carefully

• reconnect your radino32 via USB to your PC - Windows 7 will now attempt to re-install the wrong driver

• click on the pop-up window that appears on the bottom right (don't close it)

• Click on the link to cancel driver-installation

• and confirm

• Windows driver installation was cancelled

Install new driver

• Locate the driver installation files as described here: radino32_software#Installing_bootloader_drivers

• Now run zadig driver installation to install radino32 driver

• The installer recognizes the STM32 BOOTLOADER - now select libusbK and run Install Driver

• The device-manager now shows your radino32 as STM32 BOOTLOADER within section libusbK USB Devices

• The radino32 driver is now installed successfully on Windows 7