ICnova SAM9G45+XC3S700AN OEM
Contents |
Hardware
ICnova SAM9G45B+XC3S700AN OEM
The power of a complete Linux System paired with the flexibility of a tightly coupled FPGA.
The board is ready to go and only requires a single power supply voltage between 3.3V and 5V. The Linux Kernel is 100% open source and can either be downloaded or ordered as a CD.
A complete reference design for the FPGA is also available. Using an ICnova SAM9G45+XC3S700AN module, the development of the main-board can be kept simple and low-cost by avoiding a multi-layer board design.
Features:
- Atmel ARM9 AT91SAM9G45B processor with up to 400 MHz CPU clock
- 128MB DDR2-RAM
- 1MB NOR-Flash
- 256MB NAND Flash
- 1xHigh speed (480MBit) USB Host
- 1xHigh speed (480MBit) USB Device (configurable by software as 2nd Host)
- voltage regulators for 3.3V and 1.8V core voltage
- all peripherals are accessible on connectors
- extreme compact design with 40x35mm overall size
- SPARTAN 3AN FPGA from Xilinx
- 256MB DDR2 RAM connected directly to the FPGA
- 222 IOs available on the Hirose connectores, most of them supporting LVDS high speed channels
- The FPGA is mapped into the G45′s memory space through a 32bit wide interface
- The ARM is capable to configure and flash the FPGA
The ICnova SAM9G45+XC3S700AN OEM can be ordered at our Shop.
Compatible evaluation boards
In-Circuit offers a wide range of evaluation boards that can be used to develop your products and solutions while reducing your development time. These evaluation boards help you to evaluate the features and performance of selected products and system solutions. Our evaluation boards demonstrate optimized and tested solutions for your application design. These boards are designed mainly for your evaluation, design and testing purposes.
The table below shows the suitable Application Development Boards (ADB) for the ICnova SAM9G45+XC3S700AN OEM.
| Evaluation board | Main features |
|---|---|
| ADB3000 | 1x 10/100 Base-T-Ethernet-Port; 1x High-Speed-USB 2.0 Host port; 1x USB-Device Port; connector for a TFT-Touchscreen display; 1x µSD card reader; USART, SPI, I2C Interfaces; 1x µSD card reader |
Software
All Modules provided by In-Circuit usally have a Buildroot based system preinstalled, so they can be used out of the box. For some configuration a suitable Android-Image is provided, too.
The Support-CD contains all sources, incl. Linux 2.6.28, which are needed to build a toolchain and a working filesystem for the ICnova SAM9G45+XC3S700AN OEM.
