Difference between revisions of "DW1000 Tag"
From InCircuit
(→Downloads) |
(→Downloads) |
||
Line 62: | Line 62: | ||
*Datasheet: [[Media:305000106A_DW1000_Tag.pdf | Datasheet {{PAGENAME}}]]<br/> | *Datasheet: [[Media:305000106A_DW1000_Tag.pdf | Datasheet {{PAGENAME}}]]<br/> | ||
*Schematic: [[Media:schematic_dw1000_tag.pdf | Schematic {{PAGENAME}}]]<br/> | *Schematic: [[Media:schematic_dw1000_tag.pdf | Schematic {{PAGENAME}}]]<br/> | ||
− | *Arduino library for MMA7660FC: [https://github.com/reeedstudio/libraries/tree/master/DigitalAccelerometer_MMA7660FC DigitalAccelerometer MMA7660FC] | + | *Arduino library for MMA7660FC: [https://github.com/reeedstudio/libraries/tree/master/DigitalAccelerometer_MMA7660FC DigitalAccelerometer MMA7660FC] or [http://library.radino.cc/Library/DigitalAccelerometer_MMA7660FC.zip DigitalAccelerometer_MMA7660FC.zip] |
Revision as of 11:14, 5 July 2017
Hardware
Tag for Ranging / RTLS applications with radino32 DW1000 Ultra Wide Band module.
Features:
- radino32 DW1000 module
- Integrated UWB antenna
- Integrated USB-Li-ion loader for 18650 battery
- microUSB connector for battery loading
- Transparent enclosure
- Accelerometer, 3-Axis (MMA7660FC)
- 3 free programmable LEDs
Software
The DW1000 Tag will be shipped with a closed source demo-firmware.
Functionality of demo-firmware
- Communication with Anchor
- USB usable as configuration interface
- No power management: battery loader works, but the DW1000 Tag runs at full power
- Fix HF-setup (channel, band width, transmitting power)
Working with the demo-firmware command mode
- Connect the DW1000 Tag to your PC via USB
- Start a terminal program (e.g. PuTTY, HTerm, Hyperterminal, ...) with 57600 baud and 8N1
- STM32 virtual com port driver need to be installed
- After opening the connection press <Enter> once to display the menu
A)ddr:0x1234 C)han:5 X)Str:27.5 R)eload S)tore F)orceMeas:N >
Available commands:
All commands will be send by <Enter>.
aYYYY
- set address to 0xYYYY. (Vaild values: 0x0000 to 0xFFFF)
cX
- set channel to X. (Valid values: 1,2,3,4,5,7)
xYYZ
- set tx power to YY.Z dB (Range 0 to 33.5 steps of 0.5)
f
- Toggle execute measurements. The module communicates with the anchors and prints out results.
r
- reload last stored values from eeprom
s
- store current configuration to eeprom (The F option is not stored and reset on USB disconnect)
Downloads
- Datasheet: Datasheet DW1000 Tag
- Schematic: Schematic DW1000 Tag
- Arduino library for MMA7660FC: DigitalAccelerometer MMA7660FC or DigitalAccelerometer_MMA7660FC.zip