Difference between revisions of "ICnova ADB1002"
| Line 35: | Line 35: | ||
The {{PAGENAME}} and appropriate [[:Category:ICnova CPU-Modules| ICnova CPU-Modules]] can be ordered at our [http://shop.in-circuit.de/products/ICnova-CPU-Module/Entwicklungsboards/54/ICnova-ADB1002 Shop]. | The {{PAGENAME}} and appropriate [[:Category:ICnova CPU-Modules| ICnova CPU-Modules]] can be ordered at our [http://shop.in-circuit.de/products/ICnova-CPU-Module/Entwicklungsboards/54/ICnova-ADB1002 Shop]. | ||
| + | |||
| + | == Suitable CPU Modules == | ||
| + | {{Modules|intro}} | ||
| + | {{Modules|header}} | ||
| + | {{Modules|g45}} | ||
| + | {{Modules|imx353}} | ||
| + | {{Modules|footer}} | ||
== Software == | == Software == | ||
| − | + | {{Software}} | |
| − | + | ||
| − | + | ||
Revision as of 17:21, 30 September 2014
Contents |
Hardware
The ICnova ADB1002 is an evaluation board which is ideal to develop network applications. It works with all ICnova OEM Modules.
It is ideal for developing:
- Radio sniffer applications
- Home automation
- embedded Linux Board with DVI-Interface
- Wireless Gateway
The ICnova ADB1002 has the following features:
- 1x Socket for ICnova OEM Modules
- 1x Socket for ICradio OEM Modules
- 1x DVI–Interface for direct monitor support
- 1x 10/100MBit Ethernet (MII)
- 1x USB 2.0 High Speed Host (480 MBit)
- 1x USB 2.0 High Speed Device (480 MBit)
- 1x UART on Pinheader
- 1x JTAG for ICnova OEM
- 1x JTAG for Radio OEM
- 2x µSD card holder with MMI and SPI interface
- 1x Real-Time-Clock buffered with Li-Ion battery
- 1x I²C (TWI)on Pinheader
- Dimensions: 100mm x 120mm
- Power Supply from USB-Device Port or 5VDC Supply over Power Jack
- Power consumption about 1.5W
The ICnova ADB1002 and appropriate ICnova CPU-Modules can be ordered at our Shop.
Suitable CPU Modules
Software
All Modules provided by In-Circuit usally have a Buildroot based system preinstalled, so they can be used out of the box.
Login as "root" for which no password is set.
If you are new to kernel building please refer to First Steps with Buildroot.
The Board support packages listed in table above contain all sources required to build the linux image for the different combinations with the ICnova ADB1002.
If an older version of the BSP is needed please look at our Downloads section.
Generally the bootloaders on our modules are configured to loook for a bootable linux image on the SD-Card and only boot from flash if none is found.
